
Time required and Energy dissipated in Clutching Operation
Hello readers, This very important concept and still untouched by GATE and ESE. We know that the initial angular velocity of
Hello readers, This very important concept and still untouched by GATE and ESE. We know that the initial angular velocity of
1. Was it your first attempt? If no, then share experience of your previous GATE attempts. Yes it was my
Article by: Rahul Kumar (IES 2017 AIR-50, ISRO AIR-2) Estimated reading time: 3 minutes.___________________ If there are side tappings in a pipe
CASE 1: WHEN THE OUTSIDE DIAMETER OF THE HOLLOW AND SOLID SHAFT IS SAME AND THEY ARE MADE OF SAME
Concept 1: Condition for maximum power transmission Concept 2: Value of maximum power transmission and maximum transmission efficiency Concept 3: Maximum
Colour vision defect (colour blindness) is a very common defect among men. 1 out of every 12 men are affected
Consider the situation shown in above the figure. Two blocks of masses m1 and m2 are moving on the same straight line on a frictionless horizontal table. The block m2, which is ahead of m1, is going with a speed V2 smaller than the speed V1 of m1. A spring is attached to the rear […]
Dear readers, Practically speaking there is no such cycle which is reversible in nature. A reversible process is defined as
Some standard stress-strain curves: Relation between various deformations:
Dear readers, Boiling heat transfer is a common phenomenon, from the boiling of refrigerant in evaporator coils of household refrigerator
You must be logged in to post a comment.