
Common Silly Mistakes to avoid in GATE (Mechanical)
Any 4 silly mistakes in GATE can take down marks down by almost 10 and affect your rank severely. This
Any 4 silly mistakes in GATE can take down marks down by almost 10 and affect your rank severely. This
Article by: Chandresh Kr. Mahajan (Founder @exergic.in, AIR-37 ME GATE14, Ex-IOCL) Estimated reading time: 3 minutes. Note: This article is not to
Hello readers, This very important concept and still untouched by GATE and ESE. We know that the initial angular velocity of
Article by: Rahul Kumar (IES 2017 AIR-50, ISRO AIR-2) Estimated reading time: 3 minutes.___________________ If there are side tappings in a pipe
CASE 1: WHEN THE OUTSIDE DIAMETER OF THE HOLLOW AND SOLID SHAFT IS SAME AND THEY ARE MADE OF SAME
Concept 1: Condition for maximum power transmission Concept 2: Value of maximum power transmission and maximum transmission efficiency Concept 3: Maximum
Consider the situation shown in above the figure. Two blocks of masses m1 and m2 are moving on the same straight line on a frictionless horizontal table. The block m2, which is ahead of m1, is going with a speed V2 smaller than the speed V1 of m1. A spring is attached to the rear […]
Dear readers, Practically speaking there is no such cycle which is reversible in nature. A reversible process is defined as
Some standard stress-strain curves: Relation between various deformations:
Dear readers, Boiling heat transfer is a common phenomenon, from the boiling of refrigerant in evaporator coils of household refrigerator
You must be logged in to post a comment.